Optoma WHD200 Instrukcja Użytkownika

0

10 2.2 Overview 2.2.1 WHD200T (TX): PC to TV Transmitter  Front Panel Buttons and LEDs  Main Unit Back Panel

11 2.2.2 WHD200R (RX): PC to TV Receiver  Front Panel Buttons and LEDs  Main Unit Back Panel

12 2.2.3 Remote Controller Unit (RCU) Instruction POWER Button

13 3. Installation Step1: Setup the WHD200T transmitter Connect Two High-Definition Audio/Video Sources to the transmitter:

14 Step2: Setup the WHD200R receiver HDTV set Connection with WHD200R: (1) Connect the HDMI cable to the HDMI OUT jack

15 Step3: Setup the IR blaster extender cable and IR sensor extender cable If necessary, connect the Infrared (IR) blaster (or sensor) Extender ca

16 Step 4: Boot up the Transmitter and Receiver (1) Place the two AAA batteries into the remote control. (2) After the po

17 (5) During the warm-up, the POWER LED will blink in blue until the signal link between the WHD200T and the WHD200R is establ

18 (8) If all operation is normal, the POWER LED and INFO./CHANNEL LED will glow in solid blue. Please refer to the below form

19 Note: A. If the RF connection over 80sec and still not established, it might link lost or the transmitter is most likely out of range. You ma

1 Table of Contents TABLE OF CONTENTS... 1 1.

20  Press the SOURCE button on the RCU or on the top of transmitter (or receiver) for audio/video source input selection. OSD Displayed: H

21 Step 5: Mounting the WHD200 to the Wall (1) Refer the drawing of the bottom page that have relative position of the main holes and attach

22 4. Troubleshooting Problem Solution The WHD200 power indicator LED doesn't light up.  Check if the power plugs of WHD200T/WHD200R are p

23 your AV source devices. * Ensure your source devices connected to the WHD200 transmitter are powered on. * Ensure the proper cables are connecte

24 5. Supported Resolution If the SOURCE LED continues to blink in blue (slower than “no signal” mode); OSD display: , and there is no video di

25 Mandatory CEA 3D Video Format Timings Support 1280x720p @ 50Hz Top-and-Bottom YES 1280x720p @ 50Hz Frame packing YES 1280x720p @ 59.94

26 6. Audio Bit Rate Support  Digital Audio from HDMI inputs: Up to 6Mbit/s bit-rate support.  Support AC3 and DTS.  2-channel PCM: 16~2

27 7. Product Specification General Specifications Supported Video Resolutions HDMI Input 1080p, 1080i, 720p, 576p, 480p Supported Audio Forma

28

2 1. Important Information Please take the time to read this user manual before using the WHD200T and WHD200R. It contains important informatio

3 Special Notice  Never use this product nearby an aircraft or medical facility.

4 CAUTION of RF module on US region  Any changes or modifications not expressly approved by the grantee of this device could void the user&ap

5 CAUTION: Using the System in the US  Any changes or modifications not expressly approved by the grantee of this device could void the user&a

6 Industry Canada Statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two

7 systèmes de satellites mobiles utilisant les mêmes canaux; (ii) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de ra

8 2. Introduction WHD200 is a Full HD wireless transmission device. This solution delivers uncompressed 1080p full HD video and audio conten